Repairing Grease Designed to protect and restore the sites and mechanisms operating under heavy loads. Forms on the surfaces of friction pairs new cermet coating: parts grow in volume, restore the original geometry. Not be able to restore the traditional repair of high-speed rotating and heavily loaded nodes. May transfer its properties of any other regular lubrication.   Rejects heat from the friction zone Zaraschivaet scratches and microcracks Withstands high speed Reduces noise and vibration Compensates 80% wear Eliminates corrosion and protects the units from hostile environments. ​   The patented formula of this modern grease is based on a combination of revitalization HADO and complex EP (Extreme Pressure). Technical data Thickener - Lithium Color - red Consistency class - NLGI 2 Penetration at 25 ° C, 1 mm - 265 Density at 25 ° C, kg / l - 0,97 Evaporation at 120 ° C,% - <1.75 Operating temperature, ° C: A long time - <130 Briefly - <150 Dropping Point, ° C -> 186 Lubricating properties when tested on a 4-Ball (20 ± 5 ° C): Weld, N -> 2195 The critical load, N -> 823 Wear index, mm - <0,75 Note.  Typical figures The order of application When using the filler grease gun.  Add the grease in the assembly through the grease fitting until it appears from the gaps lubricated connections When using a lubricant in an aerosol can.  Spray on the lubricated parts after cleaning it from dirt Manual application.  Grease and fill half of bearing volume (unit) Eliminate the old grease Note Lubricant particularly effective for repairing bearings (10 000 rev / min.) Do not use for new assemblies and parts!