Protective grease Designed to protect the components and mechanisms operating under heavy loads. Is a universal substitute any grease and protects the surface from wear. Eliminates factory defects new bearings. At some times extends component life.   Advantages Increases component life Compensates 10% wear Smooths out scratches and microcracks Reduces noise and vibration Improves surface finish Ra to 0.06 microns Rejects heat from the friction zone Protects units from hostile environments     The patented formula of this modern grease is based on a combination of revitalization HADO and complex EP (Extreme Pressure). Tech.  information Thickener - Lithium Color - Orange Consistency class - NLGI 3 Penetration at 25 0 C, mm -1257 Density at 25 0 C, kg / l - 0,98 Evaporation at 120 ° C,% - <0.2 Operating temperature, - ° C:  A long time - <130 Briefly - <150 Dropping Point, ° C -> 189 Lubricating properties when tested on a 4-Ball (20 ± 5 ° C) Weld, N -> 2450 The critical load, N -> 1039 Wear index, mm - <0.6 Note.  Typical figures  Requirements and tolerances NLGI 3 (ASTM D217) ISO-L-XBCEB 3 (ISO 6743-9) KP3K-20 (DIN 51502)   The order of application When using the filler grease gun.  Add the grease in the assembly through the grease fitting until it appears from the gaps lubricated connections. When using a lubricant in an aerosol can.  Spray on the lubricated parts after cleaning it from dirt. Note Lubricant particularly effective for protection from wear of the bearings (10 000 rev / min.) Recommended for new parts and components