Grease replacement Designed to restore sites and mechanisms operating under heavy loads. Forms on the surfaces of friction pairs new cermet coating: parts grow in volume, restore the original geometry. Several times prolongs the life of parts.   Quickly eliminates wear Increases component life Removes scratches and microcracks Reduces noise and vibration Rejects heat from the friction zone Withstands high speed Compensates 50% wear Eliminates corrosion and protects the units from hostile environments   The patented formula of this modern grease is based on a combination of revitalization HADO and complex EP (Extreme Pressure). Technical data Thickener - Lithium Color - green Consistency class - NLGI 3 Penetration at 25 ° C, 1 mm - 255 Density at 25 ° C, kg / l - 0,97 Evaporation at 120 ° C,% - <0.65 Operating temperature, ° C: A long time - <130 Briefly - <150 Dropping Point, ° C -> 189 Lubricating properties when tested on a 4-Ball (20 ± 5 ° C): Weld, N -> 2068 The critical load, N -> 980 Wear index, mm - <0,7 Note.  Typical figures Requirements and tolerances Restoring XADO grease meets the requirements: NLGI 3 (ASTM D217) ISO-L-XBCEB 3 (ISO 6743-9) KP3K-20 (DIN 51502)   The order of application When using the filler grease gun.  Add the grease in the assembly through the grease fitting until it appears from the gaps lubricated connections When using a lubricant in an aerosol can.  Spray on the lubricated parts after cleaning it from dirt Manual application.  Grease and fill half of bearing volume (unit) Eliminate the old grease Note Lubrication is especially effective for restoring and protecting the bearings wear (10 000 rev / min.) For sites that require periodic replacement of grease in the future to use a lubricant "Protective"