Gel revitalizant for compressors and bearings   Forms on the surfaces of friction pairs new cermet coating with unique features and restores the geometry of the parts. Specially designed for restoring repair and wear protection of bearings running in an oil bath, as well as parts and components compressors of all types (except oxygen). Extends the life of the components and mechanisms by 2-4 times, significantly reducing energy and resource consumption. Enhances the performance of compressors Reduces power consumption of reciprocating compressors Reduces the time to reach the nominal parameters of the compressor Reduces energy consumption during operation of compressors Increases oil pressure Significantly reduces noise and vibration Reduces the radial clearance and axial play in the bearings Increases the precision class bearings Reduces the operating temperature of the nodes ​ Steps: The required amount of gel-revitalizant bring into the oil (maloizmeritelnoe) opening mechanism. Rolling bearings in an oil bath are processed in step 3 without replacing the oil based gel is 1.2 ml per 1 liter of oil for one regular processing step Plain bearings are processed in 6 stages the rate of 1.5 ml of gel per 1 liter of regular oil for the 1st stage of processing The total time interval between the stages of processing 20-30 hours A complete cycle is not less than 550 hours total time on the bearings from the start of the first stage Reciprocating compressors are processed in three stages the rate of 2,0 ml per 1.0 liters of regular oil for one processing step Total operating time between stages 12-24 hours A complete treatment cycle is at least 400-550 hours of compressor operating from the beginning of the first stage of processing Warning: Turbochargers, centrifugal, scroll and screw compressors are handled by individual techniques developed by technical experts HADO.