EX120 Gel revitalizant for cylinders Designed for restoring repair and protection against engine wear sleeve assembly without disassembling. Forms on the surfaces of the parts of the cylinder-piston group cermet coating. As a result, geometry is restored cylinders decreases its inner diameter disappears ellipse. These products wholesale and retail buy from the online store HADO. Increases compression.  Removes scuffs and scratches to 0.1 mm.  Protects the cylinder from wear at cold start. Reduces noise and vibration. Increases engine power. Reduces fuel consumption. Reduces CO and HC in the exhaust. Gives you the ability to selectively repair (treatment of one or more cylinders). The order of application Processing cylinder petrol engine Warm up the engine (the engine should be warm but not hot). Remove the spark plug and disconnect the central wire of the ignition timing and the switch. Two-stroke piston in the upper "dead" point (to avoid getting the gel into the intake and exhaust ports). Make Horizontal tubes 1 * (10 ml bottle) into the cylinder. Provide 15 - 20 strokes (crank, towing, turning the driving wheel, etc.). Screw candle and 3 - 4 times the starter 3 - 4 at intervals of 15 - 20. For two-stroke engines make the contents of another 1 tube (10 ml bottle) into the fuel tank. Connect the central wire, the switch and start the engine and let it idle for 15 minutes Further operation - as usual. Dosage 1 tube (10 ml bottle) - 1 cylinder 1 bottle 40 ml - 4 Cylinder